Datasheet
Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Commission Regulation (EU)
2015/830
CircuitWorks® Conformal Coating Remover Pen
Not available.
Physical state
Melting point/freezing point
Initial boiling point and
boiling range
Vapour pressure
Relative density
Vapour density
Solubility(ies)
Liquid.
Not available.
0.79
>1 [Air = 1]
Not available.
Not available.
Not available.
Odour
pH
Colourless.
Colour
Evaporation rate
<1 (butyl acetate = 1)
Auto-ignition temperature
Flash point
Not available.
Closed cup: 39°C [Tagliabue.]
Not available.
Not considered to be a product presenting a risk of explosion.
Not available.
Not available.
Viscosity
Not available.
Not available.
Odour threshold
Partition coefficient: n-octanol/
water
Upper/lower flammability or
explosive limits
Explosive properties
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
Not available.
Oxidising properties
:
9.1 Information on basic physical and chemical properties
Appearance
9.2 Other information
Decomposition temperature
:
Not available.
SECTION 9: Physical and chemical properties
Flammability (solid, gas)
:
Not available.
No additional information.
Solubility in water
:
Not available.
10.6 Hazardous
decomposition products
10.4 Conditions to avoid
Avoid all possible sources of ignition (spark or flame). Do not pressurise, cut, weld,
braze, solder, drill, grind or expose containers to heat or sources of ignition. Do not
allow vapour to accumulate in low or confined areas.
Under normal conditions of storage and use, hazardous decomposition products
should not be produced.
The product is stable.
10.2 Chemical stability
Reactive or incompatible with the following materials:
oxidizing materials
:
:
:
10.5 Incompatible materials
:
10.3 Possibility of
hazardous reactions
:
Under normal conditions of storage and use, hazardous reactions will not occur.
SECTION 10: Stability and reactivity
10.1 Reactivity
:
No specific test data related to reactivity available for this product or its ingredients.
Date of issue/Date of revision
:
3/13/2017
Date of previous issue
:
3/13/2017
Version
:
1.01
8/15