Specifications

Sicon-8 Technical Manual CircuitWerkes, Inc.
53
63 – Speak the ambient room temperature (onboard sensor)
Requires hardware version 5.60 or newer
64 – Speak the onboard silence sensor status
Requires hardware version 5.60 or newer and the audio must be unmuted in HW version 5.60
65 – X10 ‘On’ Commands (see also System Setup Menu commands # 83 & 84)
Allows you to turn on specific X10 devices by entering their two-digit unit number (01 - 16). For
example, 6501 turns on the first X10 device. 6502 turns on the second device, etc. Note that the
house code must have already been set up in advance.
66 – X10 ‘Off’ Commands
Allows you to turn off specific X10 devices by entering their two-digit unit number (01 - 16). For
example, 6601 turns off the first X10 device. 6602 turns off the second device, etc.
67 – Speak the Web Server’s Current IP Address
The IP address of the Web server will be spoken back to you. To set a static IP address, see setup
(91) function number 68.
68 – Reset Super-Admin’s Hardware access code to default (firmware 1.71+) .
If you lose your Super-admin’s hardware access code or the computer crashes, this command will
reset the Super-admin’s HARDWARE access code to 12345678. The Sicon-8 must be in local
mode for this command to operate. After entering local mode, enter 68, followed by a 1 to confirm.
90 – Play 15 Second Test Tone
This command plays a 15-second, 1-kHz tone, which can be used to adjust the hybrid null. If the
user enters a DTMF tone while the 1-kHz tone is playing, the 1-kHz tone will immediately stop. This
command can be executed from any menu by entering 90
91 – The System Setup Menu
The system setup menu can always be accessed no matter what sub menu you are in. The main
setup categories are listed below, but explained in detail through the rest of this section.
68 - Set the Sicon-8’s Internal Web Server IP to a static Address.
69 – Reboot the Sicon-8’s Internal Web Server
70 - Set the password to toggle Remote/Local mode
71 - Set Passwords
72 - Set up phone dialer memories
73 - Enable or disable individual phone dialer memories
74 - Invert DTMF relay commands
75 - Enable/disable remote toggling of Remote/Local mode
76 - Enable/disable critical alarm dial-out
77 - Enable/disable cell-phone interface
78 - Set number of rings until answer in Remote mode
79 - Set number of rings until answer in Local mode
80 - Enable/Disable Global Alarms
81 - Enable/disable the audio control mode (rec. commands via radio link)
82 – Enable/disable Push to talk relay action (for wireless links)
83 - Enable/Choose X10 Device
84 – Setup X10 House (group)
85 – Set the Time (Military format HH:MM:SS)
86 – Set the Date (MM:DD:YY)
87 – Reads current time & date
88 – Event Time Setup (001 – 128)
89 - Record a phrase