Specifications

Sicon-8 Technical Manual CircuitWerkes, Inc.
51
Channel Menu Continued
80 - Record meter label
Meter Label Recording Quick Setup Chart
Record Meter Label Enter command name below Confirm or re-enter
Chan # 80 Press * Record Your Phrase Here any key Playback 0 or 1
81 - Record status label
Status Label Recording Quick Setup Chart
Record Status Label Enter command name below Confirm or re-enter
Chan # 81 Press * Record Your Phrase Here any key Playback 0 or 1
82 – Read Alarm Setup - This command causes the Sicon-8 to read back the current channel’s alarm setup
information. Each channel reports 5 alarms (4 metering & 1of 2 Status). The Sicon-8 reports if the channel’s autoscan is
enabled, then reports the status of all five possible alarms. For critical alarms, the Sicon-8 will report any dialer memories
associated with the alarm. For action alarms, the Sicon-8 reports the channel number and relay number, if any, that is
associated with the alarm. If no dialers or relays are associated with a particular alarm, the Sicon-8 will beep and move on
to the next alarm for that channel. Note: There are six possible alarm types because the status can be setup for either
critical or action, but since it cannot be setup to be both, only five types can be simultaneously set for a given channel.
Metering Alarm Setup Reporting Format
Channel Command Report
Ch #
Autoscan? Alarm
Type
Value Alarm State Dialer or relays
01-36 82 01-36 EN or Dis 1-4 ##.## En/Dis 1, 2, etc.
Status Alarm Setup Reporting Format
Alarm Type Polarity Alarm State Dialer or relays
5-6 On/Off En/Dis 1, 2, etc.
88 – Read Status input - This command causes the Sicon-8 to read back the current channel’s
status input state.
1. Press and hold *
2. When * is released, the Sicon begins recording.
3. The Sicon stops recording either when any DTMF tone is entered, or the end of the phrase time
is reached.
4. At this point, the Sicon will play back what was recorded.
5. If you're satisfied with the recording, enter 0. To re-record the phrase, enter 1. This will take
you back to step 1.
1.
Sicon speaks current label, if any.
2. Press and hold *
3. When * is released, the Sicon begins recording.
4. The Sicon-8 stops recording either when any DTMF tone is entered, or the end of the phrase time is reached.
5. At this point, the Sicon-8 will play back what was recorded.
6. If you're satisfied with the recording, enter 0. To re-record the phrase, enter 1. This will take you back to step 1.