Specifications

Sicon-8 Technical Manual CircuitWerkes, Inc.
28
Reading Meters and Controlling Your Sicon-8
DTMF controls:
DTMF 00 – AutoScan. This DTMF command reports the status & meter readings for each active channel. An
active channel is one that has been selected during setup to be part of the AutoScan channel list. See the
channel setup sub-menu for how to enable AutoScan for each channel.
DTMF 01 through 32 – Channel Select. These DTMF commands access individual channels. When a
channel is called, it will report its current meter value and status. Entering any DTMF tone will immediately
silence whatever is being spoken.
DTMF * and # – Raise and Lower Relays. These commands operate the current channel’s raise (*) relay or
the lower (#) relay.
DTMF 77 – Read the current channel’s meter value. This command reads or re-reads the currently
selected channel’s meter value. Note that you must have selected a channel first. A typical DTMF sequence
to read only the meter value of channel 1 would be 0177.
DTMF 88 – Read the current channel’s meter value. This command reads or re-reads the currently
selected channel’s status value. Note that you must have selected a channel first. A typical DTMF sequence
to read only the meter value of channel 5 would be 0588.
Basic Control Using the Sicontroller Software:
Left:
Sicontroller’s
main display panel.
This display can be
dynamically re-sized
or minimized to the
system tray as
desired.