Specifications

3
See our web site for a full catalog: www.navair.com
NAVAIR
TECHNOLOGIES
Features
• Test and qualify your DS1 Timing & 64K Composite clocks
• Verify both Tip & Ring pair
• Measure Frequency, Voltages, Phase 360 deg. & uSec
• Simple Pass/Fail display
• Auto Fault Detection (Tip/Ring Open, No BPVs)
• Auto 10-channel test and/or Single Channel
• Local or Remote Interface Control
• Fully-Integrated with DS1/DS0 or DS310 Test BRIC
Features
• Palm PDA or PC/Laptop Graphical User Interface
• Comprehensive DS1 Test BRICK (3”x9”x1” <2lbs)
• Single or Dual-Independent DS1 Test sets in 1 Package
• Monitor both CO and Station or Drop DS0 to Butt-set
• Complete Generic & 16-bit HDSL Loopback Codes
• Smart or Intelligent Line Repeater Codes
• Add DS3, PRI-ISDN, DS0-Data & DDS circuit testing
• Add DS0-Voice, Signaling, 2-wire Signaling-TIMS
• Test and Log Results using Circuit-ID’s
• Uses Wired or BlueTooth Communication
eatures
Guisys GB 310 RITS
Intelligent Timing Test Set
GUISYS GB101: DS1 Test Set
GUISYS Pri-ISDN Test Set
Features
• Palm PDA or PC/Laptop Graphical User Interface (GUI)
• Station (PBX) and CO Modes
• Loop-Start, Ground-Start, DID, Immediate and WINK Signaling
• Generate -48vDC Battery, RINGING and Dial-tone
• Generate Tones and Measure Frequency, Level and Noise
• 2-wire 600, 900 and 1200 ohm Termination
• Monitor Line Voltages and Current
• Fully-Integrated with DS1/DS0, DS310 or PRI-ISDN Test BRICK
• Run Three to Five Independent Circuit Tests with One BRICK!
• Optional 100/135ohm Wide-band module measures to 2MHz
• Programmed tones and Auto-Sweep from 20Khz to 2MHz simplify
insertion loss measurements for xDSL line qualification
Features
• PBX (TE) or CO (NT) Modes: Emulate the CPE or the Network
• Up to 23 Simultaneous Calls on any B-Channel
• Place and Receive Voice, Data or Audio Calls
• Quick-TAP Q.931 Protocol Decodes into easy-to-read ASCII text
quickly identifies the cause of Call failures.
• BERT the selected B-Channel (2047, 511, all-1’s, etc.)
• Use Telset/Butt-set to Listen & Talk on any B-Channel
• Fully-Integrated with DS1/DS0 or DS310 Test BRICK
• Up to SIX Independent Test sets in One small test set!
• Test and Log Results using Circuit-ID’s
• Uses Wired or Wireless Communication
GUISYS GB104: Signaling Test Set with
Wideband TIMS
F
t
F
t