User`s manual

– 11 –
7. FREQUENCY MEASUREMENT
NOTE: The meter will read frequency of voltages from 10V to 600V.
➔ Plug the red test lead into V/F jack and the black test lead into COM
jack.
➔ Press the Power button.
➔ ʻ400.0ʼ, and and will appear on the display with the digit ʻ4ʼ flashing.
➔ Press
Hz
pushbutton once, ʻHzʼ will now appear on the display.
➔ Apply the test leads to the point of measurement.
➔ Read the displayed frequency with proper decimal point and symbols
(Hz or KHz).
8. TEMPERATURE MEASUREMENT
WARNING: DO NOT MEASURE TEMPERATURE OF METAL PARTS WITH VOLTAGE
PRESENT ON THEM. REMOVE ALL VOLTAGE SOURCES FROM THE CIRCUIT TO BE TESTED
BEFORE TAKING A TEMPERATURE MEASUREMENT. DISCONNECT THE TEST LEADS BEFORE
TAKING ANY MEASUREMENTS.
➔ Insert the temperature probe into TEMP socket, making sure to observe
the correct polarity.
➔ Press the Power button.
➔ ʻ400.0ʼ, and and will appear on the display with the digit ʻ4ʼ flashing.
➔ Press
°F
pushbutton once and ʻ°Fʼ will appear on the display.
➔ Touch the probe to the component you are testing and keep it there for
about 30 seconds or until the reading stabilizes.
➔ The digital reading will indicate the proper value with decimal point.
9. MIN/MAX MEASUREMENT
NOTE: When
MIN/MAX
button is pressed to go in to MIN or MAX mode, the autorang-
ing feature is cancelled and the meter will stay in the range it was last in when the
MIN/MAX
button was pressed. If a measurement being taken exceeds this range, the
meter will display the maximum range with the far left digit flashing.
NOTE: The MIN/MAX mode will not work for temperature measurements.
➔ Depending on the type of measurement required, follow the instructions
for inserting the test leads and function selection.