Technical information

Easy Automotive Modules
Evaluation Kit EASYKIT AUX DRIVES (FS50R07W1E3_B11A)
Introduction
Application Note 6 AN2012-10
Evaluation Kit EASYKIT AUX DRIVES (FS50R07W1E3_B11A)
1 Introduction
The Evaluation Kit “EASYKIT AUX DRIVES” was developed to support customers during their first steps in
designing applications with the Easy 1B Automotive B6-Bridge power module. These modules are targeted
for high voltage pumps and compressor applications within hybrid- and electric vehicles.
The application note explains how to start with the Evaluation Kit and explains the design. The information is
intended to enable the customers to re-use and modify the Evaluation Kit design for their own specific
requirements.
1.1 Safety Warning for Evaluation KIT
Please read and understand the manual and the following safety warnings.
The design operates with unprotected high voltages. Therefore, the Evaluation Kit may
only be handled by persons with sufficient electrical engineering training and experience.
The customer assumes all responsibility and liability for its correct handling and/or use of
the Evaluation Kit and undertakes to indemnify and hold Infineon Technologies harmless
from any third party claim in connection with or arising out of the use and/or handling of the
Evaluation Kit by the customer.
The Evaluation Kit is a sample to be used by the customer solely for the purpose of evaluation and testing. It
is not a commercialized product and shall not be used for series production.. The Evaluation Kit is thus not
intended to meet any automotive qualifications. Due to the purpose of the system, it is not subjected to the
same procedures regarding Returned Material Analysis (RMA), Process Change Notification (PCN) and
Product Withdraw (PWD) as regular products. See Legal Disclaimer and Warnings for further restrictions on
Infineon Technologies warranty and liability.
European legislation in relation to inter alia the restriction of hazardous substances (RoHS), waste from
electrical and electronic equipment (WEEE), electromagnetic compatibility, as well as duties to comply with
CE, FCC or UL standards do not apply to the Evaluation Kit and the Evaluation Kit may not fulfill such
requirements..
1.2 How to Order the Evaluation Kit
The Evaluation Kit has Infineon Technologies SAP number and can be ordered via Infineon Sales Partners.
EASYKIT AUX DRIVES SAP Order Number: SP001020068
a)
b)
Figure 1 Pictures of the “EASYKIT AUX DRIVES” Evaluation Kit (typical appearance).