Technical information

Easy Automotive Modules
Evaluation Kit EASYKIT AUX DRIVES (FS50R07W1E3_B11A)
Evaluation Kit CAN Terminal
Application Note 29 AN2012-10
Evaluation Kit EASYKIT AUX DRIVES (FS50R07W1E3_B11A)
nominal motor voltage phase to phase and type new voltage value – press enter to activate new value. The
new value will be shown under the Feedback value column if value is accepted successfully from the
EASYKIT. Other parameters, which are shown on the Terminal can be adjusted simply in the same way.
If you want to perform single pulse tests you can switch to page 6 (see Figure 20). Adjust the pulse length
(key “b” and type value in us) and select the switch were you want to perform the probe pulse (key “u” or “v”
or “w”) and Activate low side single pulse (key “a”).
The other pages show further analog values, fault messages, communication status, self test details… and
can give deeper details on the EASYKIT status.
Figure 19 CAN Terminal User Interface page 2 for motor control “AC Generation Setup”.