Technical information

Easy Automotive Modules
Evaluation Kit EASYKIT AUX DRIVES (FS50R07W1E3_B11A)
Evaluation Kit CAN Terminal
Application Note 28 AN2012-10
Evaluation Kit EASYKIT AUX DRIVES (FS50R07W1E3_B11A)
5.3 How to install SW on UConnect stick
Before using the CAN Terminal via the Infineon UConnect stick a software has to be flashed into the
UConnect microcontroller. The prepared SW is included in the shipped CD of the EASYKIT and can be
found under “Software\Interface\uConnect” (see .hex file).
The easiest way to flash the microcontroller is given with the Infineon MEMTOOL. The latest version can be
downloaded from http://www.infineon.com. A version can be also found on the delivery CD under
“Software\Program\Memtool\”.
Now following steps are required at the first use:
1. Connect UConnect stick on your PC
2. Open Infineon Memtool on your PC
3. Select “Target/Change…” and select the .cfg configuration file from the delivery CD under
“Software\Interface\uConnect”
4. Press Connect button (at bottom on GUI)
5. Select hex file from delivery CD “Software\Interface\uConnect”
6. Press Select All button
7. Press Add Select button
8. Press Program button
9. After press Disconnect button and target reset the program in UConnect stick starts
Now you can connect your UConnect stick to the EASYKIT CAN connector and open your terminal program
on your PC. The CAN Terminal is now ready to use.
5.4 Using the CAN Terminal Feature
The CAN Terminal is a very simple and near self explaining user interface. After a correct installation and
setup following overview screen will appear (see Figure 18).
Figure 18 CAN Terminal User Interface start-up screen “Overview”.
The pages can be changed with Key 1 to 8. The motor drive page is on page 2 “AC Generation Setup” (see
Figure 19). In this page the nominal motor parameters can be adjusted (e.g. press key “d” for adjusting the