Technical information

Easy Automotive Modules
Evaluation Kit EASYKIT AUX DRIVES (FS50R07W1E3_B11A)
Evaluation Kit CAN Terminal
Application Note 27 AN2012-10
Evaluation Kit EASYKIT AUX DRIVES (FS50R07W1E3_B11A)
5.2 CAN Terminal Quick Start Guide
The following steps are required to setup the CAN Terminal function:
1. Connect UConnect stick on your PC
2. Install SW on uConnect stick (see section 5.3)
3. Jumper CAN Control Mode on EASYKIT (see Figure 8)
4. Connect UConnect to EASYKIT CAN
5. Open terminal program on PC (select COM port from UConnect and apply 115200 Baud)
Note: please use or install a standard terminal program on your PC like Tera Term, PUTTY,…
Figure 17 EASYKIT AUX DRIVES with UConnect stick to use the CAN terminal function. CANL is
connected to D-SUB pin 2; CANH is connected to D-SUB pin7. Communication status is indicated
with blinking blue led on UConnect stick.
to PC USB port