Instruction Manual

10. Connect neutral (white ) fixture wire coming from fixture base to
neutral (usually white ) outlet wire. Fasten both wires together with a
plastic wire connector and tightly wrap the wire connector with
electrical tape.
11. Repeat the procedure with the hot (black) wires. Always make sure
that no wire strands are left outside the connectors.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS
OTHERWISE SAFETY WILL BE COMPROMISED.
12. Attach fixture base (D) to the mounting plate (A) and secure with set
screws (E); attach base (M) to plate (J) and secure with set screw (L).
Tighten with Allen wrench (C).
13. Remove socket ring (H) from socket (F), attach shade (G) onto the
socket (F) and secure with socket ring (H).
14. Insert light bulb (not included) into the socket.
15. Restore power and test fixture. Installation is complete.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
Mitchell Tail Sconce
Item # RL2590
ASSEMBLY INSTRUCTIONS
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
NOTICE:
US
M
L
I
D
S
E
T
A
I
J
K
L
M
B
E
D
G
F
H
C
Fig. 2
Fig. 1
23
5
64
"
(586mm)
5
16
"
(5.5mm)
7
32
"
(40mm)
11
16
"
(8mm)
1
37
64
"
(17.5mm)