User's Manual

84 9500CE Terminal Reference Manual
If the checksum is incorrect, data will be rejected.
Transmit Checksum
The checksum character is included in the data being
transmitted.
ON (Enabled)
Length Qualification
The weak structure of some barcodes may cause a
“short scan” error. This setting is used to prevent such
an error by qualifying the allowable barcode length to
ensure the correct barcode is read.
 Fixed Length (up to 2 lengths can be specified)
 Max / Min Length
By default, the terminal will only accepts those
barcodes with lengths that fall between the maximum
and minimum lengths; otherwise, data will be rejected.
Max / Min
Length
Maximum Length
0~127 characters 127
Minimum Length
0~127 characters 1
Interleaved 25
Supported on CCD / Laser Default
Enabled or Disabled Enabled
Start / Stop
Character
The start / stop character of the selected barcode is
included in the data being transmitted.
 Industrial 25
 Interleaved 25
 Matrix 25
Interleaved 25
Verify Checksum
When enabled, the checksum verification will be
performed in decoding.
If the checksum is incorrect, data will be rejected.
OFF (Disabled)
Transmit Checksum
The checksum character is included in the data being
transmitted.
ON (Enabled)
Length Qualification
Refer to Industrial 25 above.
 Fixed Length
 Max / Min Length
Max / Min
Length
Maximum Length
0~127 characters 126
Minimum Length
0~127 characters 1
Matrix 25
Supported on CCD / Laser Default
Enabled or Disabled Disabled
Start / Stop
Character
The start / stop character of the selected barcode is
included in the data being transmitted.
 Industrial 25
 Interleaved 25
Matrix 25