User's Manual

Chapter 5 79
5.3.1 Configure Reader Settings
Tap and hold on , and then select BC Reader or RFID Reader. If it is ticked, the reader is
enabled. Otherwise, it is disabled.
The default reader is BC Reader for reading barcodes. If the RFID Reader is installed, the
option will be available. If you need to change the factory settings, select [Settings].
The reader configurations depend on the barcode reader installed. To identify the barcode
reader, check inside the “Active Device” setting.
Active Device Description
1D Reader The scan engine is CCD or Laser.
1D Long Range Laser The scan engine is Long Range Laser or Extra Long Range Laser.
2D Reader The scan engine can read linear and 2D barcodes.
RFID The reader can read RFID tags.
Note: (1) For barcode settings, click the 1D or 2D tab that is next to the General tab.
(2) For RFID settings, click the General tab and roll to the bottom of the list.
(3) If you wish to reload the default settings, delete the ReaderCfg.ini file in
DiskOnChip.