User's Manual

Chapter 5 105
 Buffer All Symbols / Transmit Macro PDF When
Complete
(to transmit all decoded data from an entire Macro
PDF sequence only when the entire sequence is
scanned and decoded; if the decoded data exceeds
the limit of 50 symbols, no transmission because
the entire sequence was not scanned!)
 Transmit Any Symbol in Set / No Particular Order
(to transmit data from each Macro PDF symbol as
decoded, regardless of the sequence; when
selecting this mode, enable Transmit Control
Header below!)
 Passthrough All Symbols
(to transmit and decode all Macro PDF symbols
and perform no processing; in this mode, the host
is responsible for detecting and parsing the Macro
PDF sequences)
Transmit Control
Header
When enabled, it activates transmission of the control
header, which contains the segment index and the file
ID.
For example, the field may be \92800000\725\120\343.
The five digits after the \928 are the segment index (or
block index), and \725\120\343 is the file ID.
 Enable this when selecting “Transmit Any Symbol
in Set / No Particular Order” above.
 Disable this when selecting “Buffer All Symbols /
Transmit Macro PDF When Complete”.
 This has no effect when selecting “Passthrough All
Symbols”.
NO (Disabled)
Escape Characters
When enabled, it uses the backslash “\” as an Escape
character for systems that can process transmissions
containing special data sequences.
 None
 GLI Protocol
(to format special data according to the Global
Label Identifier protocol; this only affects the data
portion of a Macro PDF symbol transmission; the
Control Header, if enabled, is always sent with
GLI formatting)
None (Disabled)