User's Manual

102 9500CE Terminal Reference Manual
**“Verify Check Digit” must be disabled!
Industrial 25
Supported on 2D Reader Default
Enable Industrial 25
YES or NO NO (Disabled)
Select Discrete
Length
Refer to Interleaved 25 above. Any Length
Codabar
Supported on 2D Reader Default
Enable Codabar
YES or NO NO (Disabled)
Select Discrete
Length
Refer to Code 39 above. Any Length
CLSI Editing
When enabled, it will strip start / stop characters and
insert a space after the first, fifth, and tenth characters
of a 14-character barcode.
*This applies to 14-character barcodes only; barcode
length does not include start and stop characters. If
NOTIS is enabled, CLSI will override it.
NO (Disabled)
NOTIS Editing
When enabled, it will strip start / stop characters from a
decoded barcode.
NO (Disabled)
MSI
Supported on 2D Reader Default
Enable MSI
YES or NO NO (Disabled)
Select Discrete
Length
Refer to Interleaved 25 above. Any Length
Check Digit
Select check digit(s) to transmit and verify:
 One MSI Check Digit
 Two MSI Check Digits
One MSI Check
Digit
Transmit Check Digit
When enabled, the check digit(s) will be included in the
data being transmitted.
NO (Disabled)
Check Digit
Algorithm
With MSI barcodes, one check digit is mandatory and
always verified (using Single Modulo 10). The second
check digit is optional.
If two check digits are included, select a calculation
method for the checksum verification to be performed
in decoding.
If the checksum is incorrect, data will be rejected.
 MOD 10 / MOD 11
 MOD 10 / MOD 10
MOD 10 / MOD
11