User's Manual

94 9500CE Terminal Reference Manual
terminal will only accepts those barcodes with lengths
that fall between the maximum and minimum lengths;
otherwise, data will be rejected.
Verify Check Digit
When enabled, the checksum verification will be
performed in decoding, based on the selected
algorithm.
If the checksum is incorrect, data will be rejected.
 Disable
 USS Check Digit
(USS = Uniform Symbology Specification)
 OPCC Check Digit
(OPCC = Optical Product Code Council)
Disable
Transmit Check Digit
When enabled, the check digit will be included in the
data being transmitted.
NO (Disabled)
Convert Interleaved
25 to EAN-13
When enabled, the Interleaved 25 reading will be
expanded into EAN-13. It will then be processed
according to the settings of EAN-13.
*The barcode must have a leading zero and a valid
EAN-13 check digit.
**“Verify Check Digit” must be disabled!
NO (Disabled)
Industrial 25
Supported on (Extra) Long Range Laser Default
Enable Industrial 25
YES or NO NO (Disabled)
Select Discrete
Length
Refer to Interleaved 25 above. Any Length
Codabar
Supported on (Extra) Long Range Laser Default
Enable Codabar
YES or NO NO (Disabled)
Select Discrete
Length
Refer to Code 39 above. Any Length
CLSI Editing
When enabled, it will strip start / stop characters and
insert a space after the first, fifth, and tenth characters
of a 14-character barcode.
*This applies to 14-character barcodes only; barcode
length does not include start and stop characters. If
NOTIS is enabled, CLSI will override it.
NO (Disabled)
NOTIS Editing
When enabled, it will strip start / stop characters from a
decoded barcode.
NO (Disabled)