User's Manual

Chapter 4 錯誤! 尚未定義樣式。 57
4.2.3 AX88772 (Ethernet)
Tap and hold on “AX887721”.
Enable / Disable
Icons Description
By default, the Ethernet module is enabled.
When a Cat. 5 cable is connected, the status icon
will become .
Tap and hold on “AX887721”, and select [Disable]. The status icon will
disappear.
Properties
By default, DHCP is enabled, and therefore, there is no need to configure the IP
settings. If you want to assign a static IP address to the terminal, tap and hold on
“AX887721”, and then select [Properties].
Note: Only change these settings according to your network administrator’s instructions.