User's Manual

Chapter 5 錯誤! 尚未定義樣式。 101
 Disable
 One Check Digit
 Two Check Digits
Transmit Check Digit
When enabled, the check digit will be included in the
data being transmitted.
*By default, this feature (Not Transmit Check Digit)
only works when “Verify Check Digit” is enabled first!
NO (Disabled)
Interleaved 25 Supported on 2D Reader Default
Enable Interleaved
25
YES or NO YES (Enabled)
Select Discrete
Length
The length of a barcode refers to the number of
characters (i.e. human readable characters), including
check digit(s) it contains.
The weak structure of some barcodes may cause a
“short scan” error. To prevent this, select specific
lengths: one or two discrete lengths
 Any Length
 One Discrete Length
 Two Discrete Lengths
 Length within Range
For example, if “Length within Range” is selected, the
terminal will only accepts those barcodes with lengths
that fall between the maximum and minimum lengths;
otherwise, data will be rejected.
Any Length
Verify Check Digit
When enabled, the checksum verification will be
performed in decoding, based on the selected
algorithm.
If the checksum is incorrect, data will be rejected.
 Disable
 USS Check Digit
(USS = Uniform Symbology Specification)
 OPCC Check Digit
(OPCC = Optical Product Code Council)
Disable
Transmit Check Digit
When enabled, the check digit will be included in the
data being transmitted.
NO (Disabled)
Convert Interleaved
25 to EAN-13
When enabled, the Interleaved 25 reading will be
expanded into EAN-13. It will then be processed
according to the settings of EAN-13.
*The barcode must have a leading zero and a valid
EAN-13 check digit.
NO (Disabled)