User's Manual

Chapter 5 錯誤! 尚未定義樣式。 93
 Length within Range
For example, if “Length within Range” is selected, the
terminal will only accepts those barcodes with lengths
that fall between the maximum and minimum lengths;
otherwise, data will be rejected.
*If “Code 39 Full ASCII” is enabled, “Length within
Range” or “Any Length” is the preferred option.
Verify Check Digit
When enabled, the checksum verification will be
performed in decoding.
If the checksum is incorrect, data will be rejected.
*Only barcodes that include a Modulo 43 check digit
are decoded. Enable this feature if the barcode contains
a Modulo 43 check digit.
NO (Disabled)
Transmit Check Digit
When enabled, the check digit will be included in the
data being transmitted.
*By default, this feature (Not Transmit Check Digit)
only works when “Verify Check Digit” is enabled first!
NO (Disabled)
Code 39 Full ASCII
When enabled, Code 39 Full ASCII will be supported
instead. All the alphanumeric and special characters are
included.
NO (Disabled)
Code 93 Supported on (Extra) Long Range Laser Default
Enable Code 93
YES or NO NO (Disabled)
Select Discrete
Length
Refer to Code 39 above. Any Length
Interleaved 25 Supported on (Extra) Long Range Laser Default
Enable Interleaved
25
YES or NO YES (Enabled)
Select Discrete
Length
The length of a barcode refers to the number of
characters (i.e. human readable characters), including
check digit(s) it contains.
The weak structure of some barcodes may cause a
“short scan” error. To prevent this, select specific
lengths: one or two discrete lengths
 Any Length
 One Discrete Length
 Two Discrete Lengths
 Length within Range
For example, if “Length within Range” is selected, the
Any Length