User's Manual

8 CPT-9500 Reference Manual
Warning: Data loss may occur with SDRAM during low battery condition. Always
save data before running out of power or keep a fresh battery for
replacement.
 Warning of Low Battery & Very Low Battery
Battery Settings
Start > Settings > System tab > Power > Battery tab
 You can always monitor a low battery charge or discharged battery before you receive a
warning message indicating a low battery condition.
 A battery bar will show the progress of charging.
Start > Settings > System tab > Power > Wireless tab
 The power to the wireless module is controlled by Wireless Power Manager.
 The wireless power settings below are provided only when the wireless power is turned on
through Wireless Power Manager.
 You may need to configure these settings (Flight mode) to save battery power or avoid causing
radio interference, especially when on an airplane or in a hospital. The wireless signals may
come from Bluetooth, or 802.11b, or even both. Here you can select to turn off the wireless
signals from either of them or both. If both the check boxes are selected, it results in the same
behavior when you turn on/off the flight mode from the Connectivity button.
Start > Settings > System tab > Power > Advanced tab
 You may specify automatic turn-off times for the terminal to conserve power.
 When the terminal is turned off, it means the system is in Suspend mode, which is ready for use
but not in use.