User Manual

Chapter 4 Configuring 8500 63
¾ 802.11b/g Menu > WLAN Setting
802.11b/g system can operate in two modes (1) Ad-hoc mode: peer-to-peer, and (2)
Infrastructure mode: point to multi-point through access points.
Set the following parameters.
 Local Name:
Enter a name for identifying the terminal.
 Domain Name:
The domain name of the host is shown here.
 SS ID:
This refers to Service Set ID or Identifier.
The terminal can ONLY communicate with access
points that have the same SS ID
 System Scale:
This refers to Access Point Density.
Options - [1] Low [2] Medium [3] High
The value you set must match that set for the access
point.
 Power Saving:
This refers to the low power consumption mode.
Options - Enable or Disable
The value you set must match that set for the access
point.
 Preamble:
Options - [1] Long [2] Short [3] Both
The value you set must match that set for the access
point.