User Manual

22 Industrial 8500 Reference Manual
¾ Charging
 Make use of a serial cradle (RS-232).
 Make use of a modem cradle.
 Make use of a gang charger (charging up to four battery packs at the same time).

¾ Communications
 Wireless - make use of wireless technologies, embedded or added by module.
 Wired - make use of a cradle.
In This Chapter
2.1 Battery Pack................................................................. 22
2.2 Hand Strap................................................................... 23
2.3 Pistol Grip.................................................................... 24
2.4 Cradle, serial or modem............................................... 25
2.5 Charging ...................................................................... 30
2.6 Communications.......................................................... 30
2.1 Battery Pack
1 Place the terminal face down on a flat and clean surface.
2 Slide the battery pack into the battery compartment at a proper angle (30°~45°) so that
the tabs on the bottom of the battery are hooked in the grooves of the compartment.
Make sure that the battery is snugly fit into the compartment.
3 Hold the terminal still and slide the battery latch to lock the battery in the compartment.
Note: For a new battery, make sure it is fully charged before use.