User's Manual
Table Of Contents
- Copyright Notice
- FCC Regulations
- Care & Maintenance
- Getting Started
- Preface
- CHAPTER 1: Introducing CPT-8500
- CHAPTER 2: Installing CPT-8500
- CHAPTER 3: Software Architecture
- CHAPTER 4: Configuring CPT-8500
- CHATPER 5: Managing CPT-8500
- Specifications
- Troubleshooting
- Appendix I - Download Utilities
- Index
26 Industrial CPT-8500 Reference Manual
Figure 10: Installing pistol grip
2.4 Cradle, serial or modem
For charging and communications at the same time, a cradle is necessary.
1 Place the cradle in a flat and clean surface.
2 Connect the line of the power adaptor to the power jack on the back of the cradle.
3 Connect the power adaptor to a suitable power outlet.
4 The cradle is ready for charging.
5 If data communications are desired at the same time, connection must be established as
well. This depends on the cradle type.