User's Manual
Table Of Contents
- Copyright Notice
- FCC Regulations
- Care & Maintenance
- Getting Started
- Preface
- CHAPTER 1: Introducing CPT-8500
- CHAPTER 2: Installing CPT-8500
- CHAPTER 3: Software Architecture
- CHAPTER 4: Configuring CPT-8500
- CHATPER 5: Managing CPT-8500
- Specifications
- Troubleshooting
- Appendix I - Download Utilities
- Index
Chapter 2 Installing CPT-8500 25
Figure 9: Installing hand strap
2.3 Pistol Grip
When a pistol grip is necessary, install it to the terminal by following the steps:
1 Place the terminal face down on a flat and clean surface.
2 Remove the shield-like cover on the back of the terminal by unscrewing.
If there is a hand strap installed, remove it first. Keep the cover and screws for future use
when the pistol grip is not desired.
3 Connect the power connector from the pistol grip to the receptacle on the terminal.
4 Screw the pistol grip to the shield-like cover.
5 Make sure all screws are tightened up but not over-tightened to damage the threads.
6 Turn ON the terminal and test the trigger.