User's Manual
Table Of Contents
- Copyright Notice
- FCC Regulations
- Care & Maintenance
- Getting Started
- Preface
- CHAPTER 1: Introducing CPT-8500
- CHAPTER 2: Installing CPT-8500
- CHAPTER 3: Software Architecture
- CHAPTER 4: Configuring CPT-8500
- CHATPER 5: Managing CPT-8500
- Specifications
- Troubleshooting
- Appendix I - Download Utilities
- Index
Chapter 2 Installing CPT-8500 33
¾ Serial Cradle (RS-232)
When the cradle is set up,
1 Connect one end of a RS-232 cable to the RS-232 port on the back of the cradle.
2 Connect the other end of the cable to the RS-232 port of a host computer.
3 See the flow chart for the rest steps.
¾ Modem Cradle
When the cradle is set up,
1 For communications via an internal modem, slide the DIP switch on the back of the
cradle to right.
2 Connect the telephone line to the [Line] jack on the back of the cradle.
3 You may connect the cradle to a telephone through the [Phone] jack.
4 See the flow chart for the rest steps.
2.6.2 Wireless
The terminal is capable of wireless communications via the following technologies:
IrDA
Bluetooth
IEEE 802.11b
GSM/GPRS
Refer to 1.3.10 Wireless Support
for more details.