User's Manual
Table Of Contents
- Copyright Notice
- FCC Regulations
- Care & Maintenance
- Getting Started
- Preface
- CHAPTER 1: Introducing CPT-8500
- CHAPTER 2: Installing CPT-8500
- CHAPTER 3: Software Architecture
- CHAPTER 4: Configuring CPT-8500
- CHATPER 5: Managing CPT-8500
- Specifications
- Troubleshooting
- Appendix I - Download Utilities
- Index
Chapter 2 Installing CPT-8500 23
¾ Charging
Make use of a serial cradle (RS-232).
Make use of a modem cradle.
Make use of a gang charger (charging up to four battery packs at the same time).
¾ Communications
Wireless - make use of wireless technologies, embedded or added by module.
Wired - make use of a cradle.
In This Chapter
2.1 Battery Pack................................................................. 23
2.2 Hand Strap ................................................................... 24
2.3 Pistol Grip.................................................................... 25
2.4 Cradle, serial or modem............................................... 26
2.5 Charging ...................................................................... 31
2.6 Communications.......................................................... 31
2.1 Battery Pack
1 Place the terminal face down on a flat and clean surface.
2 Slide the battery pack into the battery compartment at a proper angle (30°~45°) so that
the tabs on the bottom of the battery are hooked in the grooves of the compartment.
Make sure that the battery is snugly fit into the compartment.
3 Hold the terminal still and slide the battery latch to lock the battery in the compartment.
Note: For a new battery, make sure it is fully charged before use.