User's Manual

14
8400 GPRS Cradle Reference Manual
2.1.2 VIEW THE CURRENT CRADLE SETTINGS
You may like to find out the current cradle settings, before or after configuring the cradle.
Such information is especially helpful when you fail to configure the cradle.
When it fails to collect information on the current settings of the cradle, the LED of Tx/Rx
will flash to indicate the cradle is not ready. A warning message is displayed along with
the error code, as shown below.
Ver: (version number)
The current firmware version of the cradle.
+CPIN: (status)
The current PIN code status.
APN: (access point name of ISP)
The current access point you are connecting to.
CHAP: (status), USER & PSW
The current status of Challenge-Handshake Authentication Protocol (CHAP). When CHAP is
enabled, user name and password are required.
DHCP & IP
The current status of DHCP server.
IP address assigned to the cradle is displayed in the second line:
 dynamic IP address when DHCP server is enabled
 static IP address when DHCP server is disabled