User's Manual

9
3. WLAN Settings
The RF settings and their default values are as follows,
1). Local Name
Specify name for terminal 8370
Default: the S/N of the 8370 terminal
2). Domain Name
The domain name locates the organization or other entity on the Internet.
Default: <None>
3). SS ID
The SSID is a 32-character (maximum) string identifying the wireless local area
network. All APs & terminals within the same service set should have the same SSID.
Default: <None>
4). System Scale
This option which depends on the Access Point Density determines when the terminal
should look for other Access Point that has bigger signal strength.
[1] Low
[2] Medium
[3] High
Default: [2] Medium
5). Power Saving
Wireless products can be put in lower power consumption mode when “Power Saving”
is enabled.
Default: [1] Enable
6). Preamble
Select either a short preamble or long preamble. Select a short preamble for 8370
terminal with high network traffic; select a long preamble when the network traffic is
low.
Default: [1] Long
4. Security
1). Authentication
802.11b supports two subtypes of network authentication services: open system and
shared key. Open system authentication is used when no authentication is required.
Under Share Key Authentication, it involves a shared secret key to authenticate the
station to the AP(access point). WEP must be implemented to utilize this.
[0] Share Key
[1] Open System
Default: [1] Open System
2). WEP Menu
 WEP Setting