User's Manual

8
program memory (FLASH) in the unit of kilobytes.
2. Initialize
To initialize the data memory (SRAM). Note the contents of the data space will be wiped
out after memory initialization.
y Power
Show the voltages of the main battery and backup battery.
y Load Application
To download the application program, BASIC run-time or font file. There are three interfaces
supported by the system, namely, the Direct-RS232, Cradle-IR and standard IrDA.
Download.exe is required when Direct RS232 or standard IrDA interface is used. And
IrLoad.exe is required when Cradle-IR is used.
y 802.11b Menu
This item will be displayed only if an 802.11b module is installed.
1. Information
It includes the WLAN LIB version, MAC ID, DHCP status, IP address, Subnet Mask, and
Gateway.
2. IP Settings
DHCP Server will dynamically assign the following IP settings to the terminal if DHCP
Server is installed and the option is enabled. These IP Settings also can be configured
manually if DHCP is disabled. Please contact your MIS engineer if you don’t know how to
configure it.
1). DHCP
DHCP stands for Dynamic Host Configuration Protocol.
Default: [1] Enable
2). SubNet Mask
The number used to identify the IP sub-network, indicating whether the IP address can
be recognized on the LAN.
Default: 255.255.128.0
3). Local IP Address
The address which identifies a location of the terminal on the network must be unique.
Default: 0.0.0.0
4). Default Gateway
the Gateway IP address is the IP address of a local router in between the forwarding
node and the remote network.
Default: 0.0.0.0
5). DNS Server
Domain Name Server is a distributed, replicated, data query service mainly used on the
Internet for translating host names to IP addresses.
Default: 0.0.0.0