User's Manual

Table Of Contents

8001 3G Cradle Reference Manual

AT+DHCP

Read Command Response

AT+DHCP?<CR> <CR><LF>ENABLE<CR><LF>

<CR><LF>DISABLE<CR><LF>

Example

AT+DHCP?

ENABLE

 DHCP is currently enabled.

Write Command Response

AT+DHCP=[Parameter]<CR> <CR><LF>OK<CR><LF>

<CR><LF>ERROR<CR><LF>

Example

AT+DHCP=0

 Disable DHCP successfully.

Remarks

The Read command is to get the Dynamic Host Configuration Protocol (DHCP) setting.

The Write command is to set the Dynamic Host Configuration Protocol (DHCP) setting, enable or

disable. [Parameter] is a character that determines whether DHCP is enabled —

 Parameter =0: Disable DHCP

 Parameter =1: Enable DHCP