User's Manual

17
Chapter 3 Usin
g
8000
t
o Configure 3G Cradle
13) Disconnect the power supply cord.
14) Re-connect the power supply cord.
Note: After powering on, the POWER indicator will become red. The TX/RX and LAN
indicators will flash by turns at the time interval of 0.25 seconds for about 30
seconds, indicating the cradle is in initialization process. Then, two flashing issues
will happen: (1) If the TX/RX indicator flashes, it means initialization fails due to
incorrect PIN; (2) If the LAN indicator flashes, it means initialization is done
successfully, either with correct PIN or PIN not required at all.
15) Perform echo tests if necessary.