User's Manual

16
8001 3G Cradle Reference Manual
Go through the following steps with each cradle:
6) Screw the antenna to the cradle.
7) Connect the power supply cord to a suitable power outlet.
Note: After powering on, the POWER indicator will become red. The TX/RX and LAN
indicators will flash by turns at the time interval of 0.25 seconds for about 30
seconds, indicating the cradle is in initialization process. Then, TX/RX indicator will
keep on flashing, indicating a failure in initialization due to lack of SIM card.
Ignore it!
8) Seat the mobile computer in the cradle.
Go to 1. Settings | 4. Default Set to reset the cradle.
9) Disconnect the power supply cord.
10) Insert SIM card to the cradle.
11) Re-connect the power supply cord.
Note: After powering on, the POWER indicator will become red. The TX/RX and LAN
indicators will flash by turns at the time interval of 0.25 seconds for about 30
seconds, indicating the cradle is in initialization process. Then, two flashing issues
will happen: (1) If the TX/RX indicator flashes, it means initialization fails due to
incorrect PIN; (2) If the LAN indicator flashes, it means initialization is done
successfully, either with correct PIN or PIN not required at all.
12) Go to 1. Settings | 3. Download to download your settings to the cradle.