User's Manual

16
8000 GPRS Cradle Reference Manual
2.1.2 VIEW THE CURRENT CRADLE SETTINGS
You may like to find out the current cradle settings, before or after configuring the cradle.
Such information is especially helpful when you fail to configure the cradle.
When it fails to collect information on the current settings of the cradle, the LED of Tx/Rx
will flash to indicate the cradle is not ready. A warning message is displayed along with
the error code, as shown below. Refer to ᙑᎄ! ބլࠩ೶ᅃࠐᄭΖ.
Ver: (version number)
The current firmware version of the cradle. Refer to ᙑᎄ! ބլࠩ೶ᅃࠐᄭΖ.
+CPIN: (status)
The current PIN code status. Refer to ᙑᎄ! ބլࠩ೶ᅃࠐᄭΖ.
APN: (access point name of ISP)
The current access point you are connecting to. Refer to ᙑᎄ! ބլࠩ೶ᅃࠐᄭΖ.
CHAP: (status), USER & PSW
The current status of Challenge-Handshake Authentication Protocol (CHAP). Refer to ᙑᎄ! ބլࠩ
೶ᅃࠐᄭΖ. When CHAP is enabled, user name and password are required.
DHCP & IP
The current status of DHCP server. Refer to ᙑᎄ! ބլࠩ೶ᅃࠐᄭΖ.
IP address assigned to the cradle is displayed in the second line:
dynamic IP address when DHCP server is enabled
static IP address when DHCP server is disabled