User's Manual

Installing 5000/5100:

Setting up the terminal

Figure 16: Wiring & connecting

Wiring & Connecting

7. Attach connectors of the keyboard module, reader module, charger or battery

pack to receptacles on the PCB.

8. Follow the wiring instructions to insert every wire to a corresponding slot of the

terminal blocks

. Tighten screws to secure wires. Then plug the terminal block

in to the PC board socket.

z Connect line power.

z Connect digital inputs and outputs.

z Connect RS-232, if necessary

z Connect RS-485, if necessary

9. If the Ethernet card

is installed, simply connect a standard networking cable

(two ends with RJ-45 connectors) to the Ethernet ports on the module and your

networking device.

Proceed to enable TCP/IP and set other networking parameters.