User's Manual

Installing 5000/5100:

Setting up the terminal

Figure 14: Drilling holes & assembling cables

Drilling Holes & Assembling Cables

1. Make use of the mounting template provided in the appendix, and drill four holes

in an appropriate location for installing the terminal:

z Each hole shall be 6 mm in diameter and 21 mm in depth.

z The four holes enclose a square of 120 mm x 120 mm.

2. Insert the four wall plugs (screw anchors for concrete surface) into the four holes.

Make sure each of them is completely inside a hole.

3. Pull cables through the cable entry hole

. Apply the two-piece cable holder

to organize the in-coming cables, and secure the holder to the pole

by screw.