User Manual

Enter Setup

1660 Barcode Scanner

User Guide

3.1 CONNECTING VIA 3610

Connect 3610 to the USB port of PC, and then connect the scanner to 3610. You can

have up to seven scanners connected to one computer at the same time.

Note: If you are using USB Virtual COM for the first time, you must install its driver from

the CD-ROM.

3.1.1 CONNECT TO 3610

By default, the interface of 3610 is set to “USB HID”. You can connect any scanner to

3610 by having the scanner read the two labels at the back of 3610.

 “Set Connection” label

 “Serial Number” label

The scanner will respond with one beep when reading the “Set Connection” label, and

two beeps (low-high tone) when reading the “Serial Number” label.

After reading these labels, the scanner will stay active for 2 minutes trying to connect to

the 3610 dongle while its LED is flashing blue (On/Off ratio 0.5 s: 0.5 s). Once connected,

the scanner will respond with three beeps (tone ascending from low to high), and the

LED becomes flashing blue (On/Off ratio 0.02 s: 3 s). When getting out of range, the

scanner will respond with three short beeps (tone descending from high to low).

Read the “Set Connection” label first, and then the “Serial Number” label within 5

seconds. If the “Set Connection” label on 3610 is illegible, try this one —

Note: The 3610 settings will overwrite the interface-related settings on the scanners that

are currently connected to 3610.

Set Connection