User Manual

58
Enter Setup
1660 Barcode Scanner
User Guide
2.4 USB VIRTUAL COM VIA 3610
Connect 3610 to the USB port of PC, and then connect the scanner to 3610. You may run
HyperTerminal.exe on your computer, and the scanned data will be transmitted to the
computer.
Note: If you are using USB Virtual COM for the first time, you must install its driver from
the CD-ROM.
2.4.1 ACTIVATE USB VIRTUAL COM
2.4.2 INTER-FUNCTION DELAY
By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254,
to match the computer response time of the keyboard interface. Such delay time is
inserted between every function code (0x01 ~ 0x1F) being transmitted. The longer the
delay time is, the slower the transmission speed will be.
Value
Delay Time Value Delay Time
0 Disable 195 ~ 204 200 millisecond
1 ~ 14 10 millisecond 205 ~ 214 210 millisecond
15 ~ 24 20 millisecond 215 ~ 224 220 millisecond
25 ~ 34 30 millisecond 225 ~ 234 230 millisecond
35 ~ 44 40 millisecond 235 ~ 244 240 millisecond
45 ~ 54 50 millisecond 245 ~ 254 250 millisecond
… …
1) Read the label above to specify the inter-function delay.
2) Read the “Decimal Value
” label on page 169 for the desired inter-function delay
(millisecond).
3) Read the “Validate” label on the same page to complete this setting.
Activate USB Virtual COM
Inter-Function Delay … (*0 ~ 25
4
)