User Manual

21
Update
Chapter 1 錯誤! 使用 [常用] 索引標籤將 Heading 1 套用到您想要在此處顯示的文字。
1.3 LED INDICATOR
The triple-color LED on top of the scanner is used to provide user feedback. For example,
the LED becomes solid red and goes off quickly upon powering on or running out of
transmit buffer. You may tell the difference by the beeps – you will hear a long beep of
high tone when powering on the scanner, and a long beep of low tone when the transmit
buffer becomes full.
Scanner LED
Meaning
Red,
flashing
Charging (On/Off ratio 0.5 s: 0.5 s)
Red,
solid
Charging error
Red,
on-off
 Power on, with one long beep (high tone, LED on for 1 s)
 Transmit buffer full, with one long beep (low tone)
 Memory full, with two short beeps (high-low tone)
Green,
on-off
Good Read, with one short beep (high tone) and beeper pitch and
duration programmable
Blue,
flashing
First, flashing blue (On/Off ratio 0.5 s: 0.5 s) for two minutes
indicates the scanner is waiting for connection, and goes off if no
connection is established, then flashing red (On/Off ratio 0.5 s: 2
s) indicates the scanner is inactive.
It is ready for connection only while the LED is flashing blue —
 SPP: waiting host to connect
 HID: trying to connect to host
 Using 3610: trying to connect to 3610
Red,
flashing
Flashing red (On/Off ratio 0.5 s: 2 s) indicates the scanner is
inactive and its CPU running at low speed to save power —
 No WPAN connection is established after waiting for two
minutes
Blue,
flashing
Flashing blue (On/Off ratio 0.1 s: 0.1 s) indicates the scanner
receives a PIN code request from host (flashing more quickly
than waiting connection).
Blue,
flashing
Flashing blue (On/Off ratio 0.02 s: 3 s) indicates the scanner has
established a WPAN connection successfully.
Red,
flashing
Blue,
flashing
Flashing red and blue indicates an error occurs while entering the
PIN code. Press the [Trigger] key to get ready for re-connecting.
Red,
flashing
Configuration Mode (On/Off ratio 1 s: 1 s)