User Manual

163

Update

Appendix II 錯誤! 使用 [常用] 索引標籤將 Heading 1 套用到您想要在此處顯示的文字。

3610 SERIAL COMMANDS

Normally, you can configure the 3610 dongle by having a connected scanner read

3610-related setup labels.

1) Connect 3610 to the USB port of PC. You may need to install its driver first!

2) Refer to 3.1.1 Connect to 3610

for the target scanner to connect to 3610.

Read the “Set Connection” label first, and then the “Serial Number” label within 5

seconds. Both labels can be located at the back of 3610. After reading these labels,

the scanner will stay active for 2 minutes trying to connect to 3610 while its LED is

flashing blue (On/Off ratio 0.5 s: 0.5 s). Once connected, the scanner will respond

with three beeps (tone ascending from low to high), and the LED becomes flashing

blue (On/Off ratio 0.02 s: 3 s).

3) Read the following labels in sequence to configure 3610.

For 3610-related setup labels, refer to the Serial Command table below. Note that for

the “Version” and “GetID” labels, you must run HyperTerminal.exe or any text editor

to receive the information.

 If the output interface is USB Virtual COM, run HyperTerminal.exe on your

computer to receive the information.

 If the output interface is USB HID, run any text editor to receive the information.

nter Setup

(3610-related setup labels)

pdate