User's Manual

Quick Start
But for a number of special parameters, multiple reads are required to complete the setting.
In this case, the scanner will respond with a short beep to indicate it needs to read more
setup barcodes. These special parameters may require reading one or more setup barcodes,
such as
 Numeric barcodes, say, for keyboard type, inter-character delay, length qualification
 Hexadecimal barcodes, say, for character strings as prefix, suffix, etc.
 When “BT HID”, “USB HID” or “Keyboard Wedge” is configured for interface, Key Type
and Key Status will then become applicable. You may decide whether or not to change
key status when “Normal Key” is selected for Key Type.
To complete the configuration of these special parameters, it requires reading the “Validate”
barcode, and the scanner will respond with two beeps (low-high tone) to indicate the input
values are validated.
The example below shows how to save your settings as “User Default” so that you may
restore user defaults at a later time:
Steps Action User Feedback if Successful
1 Power on the scanner… The scanner will respond with a long
beep
(high tone)
and its LED indicator will
become solid red and go off quickly.
15
Update