User's Manual

81
Update
Chapter 2 Selecting Output Interface
2.5 RS-232 VIA BT CRADLE
Use the RS-232 cable to connect the scanner via cradle to the serial port of PC, and connect
the power supply cord. The associated RS-232 parameters must match those configured on
the computer. You may run HyperTerminal.exe on your computer, and the scanned data will
be transmitted to the computer.
RS-232 Settings
Defaults
Baud Rate, Data Bit, Parity, Stop Bit 115200 bps, 8 bits, No parity, 1 stop bit
Flow Control None
Inter-Character Delay 0 (ms)
Inter-Function Delay 0 (ms)
ACK/NAK Timeout 0
ACK/NAK Beep Disable
2.5.1 ACTIVATE RS-232 INTERFACE
Activate Cradle
RS-232 Interface
2.5.2 BAUD RATE
*115200 bps
57600 bps
38400 bps
19200 bps
9600 bps