User's Manual

225
Update
Chapter 6 Applying Forma
t
s for Data Editin
g
6.3.2 DATA LENGTH
The length must include prefix, suffix (0x0d by default), length code, etc. By default,
barcodes of any length (character count) are eligible for data editing.
 Specify a value.
 When zero is given to both, the scanner will not perform the length qualification.
1) Read the barcode below to specify Max. Length or Min. Length separately, and follow
steps 2~3.
Max. Length
Min. Length
2) Read the “Decimal Value” barcode on page 263 for the desired length.
3) Read the “Validate” barcode on the same page to complete this setting.
6.3.3 MATCHING STRING & LOCATION
By default, no matching string is specified, and therefore, it is disabled. You may enable this
feature by specifying a matching string; up to four characters are allowed.
 When the Matching String Location is zero, the scanner will only check for the existence
of the matching string in the barcode data.
 Specify a value to indicate where the matching string starts in the barcode data.
1) Read the barcode to specify a matching string.