User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
86
1800 Series Handheld RFID Reader Reference Manual
4) In the Generic Bluetooth
®
Radio Properties window, select Advanced tab to see the Bluetooth
®
MACID of host computer.
5) Enable HyperTerminal on the host computer and configure the variables required for
Bluetooth
®
SPP Master connection.
Command
#@bt_target=0,0015834fbe42 → configure the type and MACID of connected device
Response (s)
OK
Note: When any changes are made to Bluetooth
®
type, it is suggested to reset the
Bluetooth
®
connection by “#@bt_reset” command. Refer to 3.3.2 Reset a
Connection.
6) On the host computer, a Bluetooth
®
connection information box will pop-up on the lower right
of the taskbar. Click it.