User's Manual

Table Of Contents

1800 Series Handheld RFID Reader Reference Manual

Note: When Bluetooth

security is enabled without providing a pre-set PIN code, the

random PIN code is supported.

11) Now the RFID Reader will be listed as shown below.

Note: When any changes are made to authentication and PIN code on the RFID Reader,

or you want to change RFID Reader to use Bluetooth

HID, it is suggested to

remove the connected RFID Reader from the paired device list (called unpairing)

first and go through the whole process to re-establish the connection.

12) Run the desired application on your computer, such as HyperTerminal.exe if using Bluetooth

SPP or Notepad.exe if using Bluetooth

HID.

Once the desired application is configured completely, the status of the RFID Reader listed on

the device list will be showed as “Connected”, indicating the WPAN connection is established

successfully via the outgoing COM port if using Bluetooth

SPP Slave.

Note: Even though the RFID Reader is connected to the host with authentication disabled

(= no PIN code required), the host may still request a PIN code while the

application is opening COM port. A random PIN code is supported so that you can

input a matching PIN code on the RFID Reader. Refer to

3.1.2 Configure Related

Settings

ect