User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
73
Chapter 3
Settin
g
Up a WPAN Connection
3.1.2 CONFIGURE RELATED SETTINGS
Bluetooth Discoverable
RFID Reader can be configured to hide itself from other devices equipped with Bluetooth
®
wireless
technology. Simply disable the device name broadcasting setting so that it won’t be discovered by
any other computers.
Command:
#@bt_visible?\r
Purpose Get Bluetooth
®
Discoverable Status
Response OK,[m]\r (Default m= ‘1’)
[m]: Discoverable
‘0’ – Disable
‘1’ – Enable
ERR,[code]\r
#@bt_visible=[m]\r
Purpose Set Bluetooth
®
Discoverable Property
Response OK\r
ERR,[code]\r
Note: By default, device name broadcasting is enabled (which is required for initial
connection).
BT POWER SAVING
By default, this feature is enabled, meaning the RFID Reader will listen to the wireless network at a
reduced rate.
Command:
#@bt_ps?\r
Purpose Get Bluetooth
®
Power Saving
Response OK,[m]\r (Default m= ‘1’)
[m]: Power Saving
‘0’ – Disable
‘1’ – Enable
ERR,[code]\r
#@bt_ps=[m]\r
Purpose Set Bluetooth
®
Power Saving
Response OK\r