User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
72
1800 Series Handheld RFID Reader Reference Manual
3.1 CONNECTING VIA BLUETOOTH
®
DONGLE
3.1.1 CHANGE INTERFACE
Before establishing a WPAN connection, you can configure the Bluetooth
®
connection
interface via the USB port.
In the HyperTerminal window, issue “#@bt_type=” command to change the connected
interface and issue “#@bt_type?” command to confirm the used interface at present.
“Activate Bluetooth
®
HID”, the parameter is ‘5’.
“Activate Bluetooth
®
SPP Slave Mode”, the parameter is ‘0’.
“Activate Bluetooth
®
SPP Master Mode”, the parameter is ‘3’.
For example, if you want to use SPP Slave for a connection type, see below:
Command
#@bt_type=0 → set connected interface to ‘0’ for SPP Slave Mode
Response (s)
OK