User's Manual

61
Chapter 2 Communication Interface
2.6 USB VCOM AND HID VIA 3610
Note: If you are using USB VCOM for the first time, you must install its driver from the
CD-ROM. Driver version 5.4 or later is required. Please remove older versions!
Refer to
2.1 USB Interface.
For USB VCOM and HID via 3610, connect 3610 to the USB port of host computer, and
then connect RFID Reader to 3610 via Bluetooth
®
. Before the Bluetooth
®
connection
between 1800 and 3610 is able to be established, users have to connect a USB cable
between them to tell 1800 the information about 3610 via the “bt_target” command.
To capture the data, run any text editor on host computer. The scanned data will be
transmitted to the host computer.
How to connect with the 3610?
Two parameters are necessary using “#@bt_target” command to make a connection with 3610.
One is to configure connect type as 3610; and the other is serial No. of the target machine.
Command:
#@bt_target?\r
Purpose Get Bluetooth
®
Target Machine
Response OK,[m],[n]\r
[m]: Bluetooth
®
Type, ‘0’ – SPP Master, ‘1’ – 3610
[n]: MACID of target Machine or S/N of 3610
ERR,[code]\r
#@bt_target=[m],[N]\r
Purpose Set Bluetooth
®
Target Machine
Response OK\r
ERR,[code]\r
Example:
Command
#@bt_target=1,BS9001346 → set target to 3610 with S/N:BS9001346
Response (s)
OK