User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
Version Date Notes
1.04 Nov. 13, 2014
Modified: 1.5 – Command Beep is disabled by default
Modified: 4.3.3 – #@rf_sepc1 corrected to #@rf_sepcl (example
code)
Modified: 4.6.1 – default Q value for 1862 added
Modified: 4.6.2 – default Output Power level for 1862 added
Modified: 5.2.3 EPC Tag Section – descriptions for
“#@dat_rfspr=” added
Modified: Specifications – 1862 added
1.03 Oct. 07, 2013
Modification: 1.1.4 Low Battery Alarm – Charging status
definition added to SYS_BATTERY command
Modification: 1.8 Event events sent via USB & bit 9 definition
added to SYS_EVT command
Modification: Appendix IV Status Code – code table updated
1.02 May. 27, 2013
Modification: 1.2.1 Transmit Buffer –
Transmission Buffer
commands revised/added
(SYS_TXBEN, SYS_TXBUP,
SYS_TXBCLR)
Modification: 1.2.2 Memory Mode -
SYS_MEMUP command
revised
New: 1.8 Event added (SYS_EVT command)
Modification: 4.5.2 Read/Write Tag – “RF_RWIDX” memory
bank value revised
New: 4.6.1 Applications in Multiple Tags Environment –
RF_Q
command added
New: 4.6.2 Adjustment for Output Power Level of the
Reader – RF_PLV command added
New: 5.4 Output EPC Data via USB Virtual COM DAT_2USB
command added
Modification: Ch. 6 Alternate Mode -
#@dat_ostr=1,#@iOSKBD
command added
1.01 Dec. 17, 2012
Revised according TC manual
1.00 Sep. 18, 2012
Initial Release
RELEASE NOTES