User's Manual

22
1800 Series Handheld RFID Reader Reference Manual
Press <F1>+<F2> keys for 3 seconds with two short beeps, high tone and then release
both keys to force the RFID Reader to shut down. Alternatively you can also issue
command on the host computer described below to power off the RFID Reader.
Command:
#@sys_off\r
Purpose System Shutdown
Response OK\r
ERR,[code]\r
1.1.3 POWER SAVING MODE
Power Saving (1~254 min.; 0= Disable): By default, it is set to idle at full-speed for 2
minutes before it enters power saving mode. If this feature is not desired, set it to 0.
Note: The Power Saving setting will not take effect when data is transmitting via
Bluetooth
®
HID or SPP.
Command:
#@sys_tps?\r
Purpose Get the Delay Time of Power Saving Mode
Response OK,[m]\r (Default m= ‘2’)
[m]: ‘0’ ~ ‘254’ (Unit=minute)
ERR,[code]\r
#@sys_tps=[m]\r
Purpose Set the Delay Time of Power Saving Mode
Response OK\r
ERR,[code]\r
Note: Power Saving will not take effect when one of the following conditions is met:
(1) RFID Reader is being configured by the 1800 Configuration Utility.
(2) The scanning mode is set to Test Mode.
(3) The setting value of Power Saving is greater than Auto Power Off.