User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
12
1800 Series Handheld RFID Reader Reference Manual
9) After finishing ASCII Setup, in the Properties configuration window, click “OK”.
CONFIRMING THE USB CONNECTION
Now, you can begin to issue commands between the host computer and RFID Reader.
For example, you can issue “#@sys_info?” command for testing. If the connection is
successful, the HyperTerminal will display the following response from the reader.